Tretromls rundbøyemaskin

Kramer RHM III 120/1000

Type RHM III 120 v-1000
Roll diameter: 120 mm
Usable length: 1000 mm
Sheet thickness up to 5.0 mm
400 Volt
Kramer Maschinenbau GmbH

Description
The features described for the RH II series also apply to the RHM III series. These round bending machines are designed for continuous operation under maximum load. The lower roll is adjustable via a worm gear.

For model sizes RHM III 90 – RHM III 130, the gear brake motor is flange-mounted on the exterior, while models RHM III 140 to RHM III 180 are equipped with an internally flange-mounted gear brake motor.

All powered machines are equipped as standard with an electric safety control system. Forward and reverse operation is performed via a dual footswitch.

Additional features for Type RHM III:
▪ Powerful gear brake motor, thermally protected
▪ Electric safety control system
▪ Convenient dual footswitch for forward and reverse
▪ Three-roll drive (especially recommended for thin sheet applications)
▪ Drive control with 2 operating speeds
▪ Overload protection via slip clutch
▪ Motorized adjustment of rear and lower rolls

Standard equipment:
▪ Gear train
▪ Three-roll configuration
▪ Asymmetrical roll arrangement
▪ Swing-out upper roll to the front
▪ Manual adjustment of lower and rear rolls via handwheel
▪ Conical bending achieved by tilting the lower and rear rolls
▪ Pre-bending performance = round bending performance

Optional equipment:
▪ Device for conical rolling
▪ Upper roll with folding groove
▪ Lower and rear rolls with wire insertion groove
▪ Surface-hardened rolls
▪ Ground rolls
Knjdpfox Niu Nsx Ag Sof

Annonsen ble oversatt automatisk. Oversettelsesfeil kan forekomme.