Lav laster

Fliegl TPS 118 Bau m Heckanschrägung

Further information
Chassis central axle trailer
Welded fine-grained steel construction
6 pairs of lashing eyes bolted to the outside of the floor/outer frame, 5 tons each
2 pairs of lashing eyes additionally bolted to the floor, 5 tons each in the corners
Gear support foot at the front
Folding rear support
2 wheel chocks with holder
Steel underride guard
Rear spray flaps across the entire width
Quarter-shell mudguards
1 plastic tool box, with shelf, w=620/h=360/t=440 mm, lockable with a padlock. (lock not included in scope of delivery)
Towing device central axle trailer
Towing bar with tested 40 mm towing eye
Height-adjustable drawbar via spindle, max. adjustment range 300 mm
Axles + suspension
Drum brake axles, manufacturer's choice
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load compensation (rocker compensation)
Wheels and tires
235 / 75 R 17,5
manufacturer's choice
Factory silver steel rims
Brake system
2-line compressed air brake system
Hand spindle parking brake
Nwedpfx Aoi Rixrjg Djp
Integral air reservoir
2 non-interchangeable coupling heads at the front, with connecting cables to the motor vehicle,
ABS and ALB, with ABS plug at the front, with connecting cable
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the side
2 white position lights at the front
2 white/red lane departure lights at the rear
2 x 7-pin interchangeable plugs at the front, with connecting cable,
Floor
Steel/ checker plate floor for high point load capacity
Note: Slight floor corrugation possible due to welding distortion!
Platform length approx. 5,200 mm
Rear sloping to approx. 900 mm
Front wall / front corner stanchions
25 mm aluminum hollow profile, 400 mm high,
Drop sides
25 mm aluminum hollow profile, 400 mm high, foldable and removable
Rear wall / rear corner stanchions
1 pair of steel stanchions attached to the frame and with bracket for locking the drive-on ramps, drive-in width approx. 2,430 mm
Drive-on ramps
2 steel ramps 2,300 mm long, 510 mm wide, can be moved sidewayswith grab handle on the ramps
covered with 3 toothed steel rails
With gas pressure jack for one-man operation
Country of registration/plates
Country of registration: Germany
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective strips in accordance with ECE R 048, white on the sides and red on the rear
Paintwork
Hot-dip galvanized frame incl. passivation
15-year warranty against rusting through
Front wall aluminum
Side wall anodized aluminium
Drive-on ramps Hot-dip galvanized
Attention! These are archive pictures.

Annonsen ble oversatt automatisk. Oversettelsesfeil kan forekomme.